Description

Syvecs S7i ECU

This is the “entry level” Syvecs ECU. Although relatively basic it features, traction control, drive by wire, and CAN bridge, making it a very powerful tool indeed with 16 x Inputs, 16 x Fuel Outputs, 6 x Ignition TTL Outputs, 1 x Lambda Input, 1 x Knock Input and 1 x EGT Input. All software features are enabled from factory – Does not support Direct Injection Control or Paddle-shift Control!

Should you need a plug and pin kit or any upgrades and options, please go here.

Any sensors needed can be bought here.

Specifications:

100 MHz full duplex ethernet for connection to PC for programming and data download
1 CAN 2.0B interface
16 general purpose analogue inputs:
– 4 5V/bipolar, sensor/sync/speed, programmable trigger voltages
– 4 5V/Thermistor, sensor/sync/speed, fixed trigger voltages
– 4 5V sensor input
– 4 Thermistor sensor input
1 NTK/LSU lambda circuit
1 K-type thermocouple circuit
1 knock input
16 low side driver outputs:
-8 injection outputs (Max 10 amps)
-8 ancillary outputs (Max 5 amps)
6 logic level ignition outputs (5 or 12v)
1MB Battery backed internal logging memory
6 to 26v input voltage range with reverse polarity protection
2 regulated 5V sensor supply outputs with protection
Unregulated sensor supply output which tracks the ECU supply voltage
5 Seperately protected sensor and communication ground inputs
Dimensions : 181 x 160 x 51.5 mm